riscv: dts: starfive: disable unused csi/camss nodes

Aurelien reported probe failures due to the csi node being enabled
without having a camera attached to it. A camera was in the initial
submissions, but was removed from the dts, as it had not actually been
present on the board, but was from an addon board used by the
developer of the relevant drivers. The non-camera pipeline nodes were
not disabled when this happened and the probe failures are problematic
for Debian. Disable them.

CC: stable@vger.kernel.org
Fixes: 28ecaaa ("riscv: dts: starfive: jh7110: Add camera subsystem nodes")
Closes: https://lore.kernel.org/all/Zw1-vcN4CoVkfLjU@aurel32.net/
Reported-by: Aurelien Jarno <aurelien@aurel32.net>
Reviewed-by: Emil Renner Berthing <emil.renner.berthing@canonical.com>
Tested-by: Aurelien Jarno <aurelien@aurel32.net>
Reviewed-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Conor Dooley <conor.dooley@microchip.com>

Author: ConchuOD

arch/riscv/boot/dts/starfive/jh7110-common.dtsi

@@ -128,7 +128,6 @@
 	assigned-clocks = <&ispcrg JH7110_ISPCLK_DOM4_APB_FUNC>,
 			  <&ispcrg JH7110_ISPCLK_MIPI_RX0_PXL>;
 	assigned-clock-rates = <49500000>, <198000000>;
-	status = "okay";
 
 	ports {
 		#address-cells = <1>;
@@ -151,7 +150,6 @@
 &csi2rx {
 	assigned-clocks = <&ispcrg JH7110_ISPCLK_VIN_SYS>;
 	assigned-clock-rates = <297000000>;
-	status = "okay";
 
 	ports {
 		#address-cells = <1>;