gpiolib: Show more info for interrupt only lines in debugfs

Show more info for interrupt only lines in debugfs. It's useful
to monitor the lines that have been never requested as GPIOs,
but IRQs.

Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Link: https://lore.kernel.org/r/20240530191418.1138003-3-andriy.shevchenko@linux.intel.com
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

Author: andy-shev

drivers/gpio/gpiolib.c

@@ -4795,11 +4795,11 @@ static void gpiolib_dbg_show(struct seq_file *s, struct gpio_device *gdev)
 
 	for_each_gpio_desc(gc, desc) {
 		guard(srcu)(&desc->gdev->desc_srcu);
-		if (test_bit(FLAG_REQUESTED, &desc->flags)) {
+		is_irq = test_bit(FLAG_USED_AS_IRQ, &desc->flags);
+		if (is_irq || test_bit(FLAG_REQUESTED, &desc->flags)) {
 			gpiod_get_direction(desc);
 			is_out = test_bit(FLAG_IS_OUT, &desc->flags);
 			value = gpio_chip_get_value(gc, desc);
-			is_irq = test_bit(FLAG_USED_AS_IRQ, &desc->flags);
 			active_low = test_bit(FLAG_ACTIVE_LOW, &desc->flags);
 			seq_printf(s, " gpio-%-3u (%-20.20s|%-20.20s) %s %s %s%s\n",
 				   gpio, desc->name ?: "", gpiod_get_label(desc),