i3c: master: Add inline i3c_readl_fifo() and i3c_writel_fifo()

The I3C abstraction expects u8 buffers, but some controllers operate with
a 32-bit bus width FIFO and cannot flag valid bytes individually. To avoid
reading or writing outside the buffer bounds, use 32-bit accesses where
possible and apply memcpy for any remaining bytes

Signed-off-by: Jorge Marques <jorge.marques@analog.com>
Suggested-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Reviewed-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Reviewed-by: Frank Li <Frank.Li@nxp.com>
Link: https://lore.kernel.org/r/20250624-i3c-writesl-readsl-v3-1-63ccf0870f01@analog.com
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Author: gastmaier

drivers/i3c/internals.h

@@ -22,4 +22,41 @@ int i3c_dev_enable_ibi_locked(struct i3c_dev_desc *dev);
 int i3c_dev_request_ibi_locked(struct i3c_dev_desc *dev,
 			       const struct i3c_ibi_setup *req);
 void i3c_dev_free_ibi_locked(struct i3c_dev_desc *dev);
+
+/**
+ * i3c_writel_fifo - Write data buffer to 32bit FIFO
+ * @addr: FIFO Address to write to
+ * @buf: Pointer to the data bytes to write
+ * @nbytes: Number of bytes to write
+ */
+static inline void i3c_writel_fifo(void __iomem *addr, const void *buf,
+				   int nbytes)
+{
+	writesl(addr, buf, nbytes / 4);
+	if (nbytes & 3) {
+		u32 tmp = 0;
+
+		memcpy(&tmp, buf + (nbytes & ~3), nbytes & 3);
+		writel(tmp, addr);
+	}
+}
+
+/**
+ * i3c_readl_fifo - Read data buffer from 32bit FIFO
+ * @addr: FIFO Address to read from
+ * @buf: Pointer to the buffer to store read bytes
+ * @nbytes: Number of bytes to read
+ */
+static inline void i3c_readl_fifo(const void __iomem *addr, void *buf,
+				  int nbytes)
+{
+	readsl(addr, buf, nbytes / 4);
+	if (nbytes & 3) {
+		u32 tmp;
+
+		tmp = readl(addr);
+		memcpy(buf + (nbytes & ~3), &tmp, nbytes & 3);
+	}
+}
+
 #endif /* I3C_INTERNAL_H */