Merge tag 'drm-misc-next-2024-09-20' of https://gitlab.freedesktop.org/drm/misc/kernel into drm-next

drm-misc-next for v6.12:

UAPI Changes:
- Add panthor/DEV_QUERY_TIMESTAMP_INFO query.

Cross-subsystem Changes:
- Updated dt bindings.
- Add documentation explaining default errnos for fences.
- Mark dma-buf heaps creation functions as __init.

Core Changes:
- Split DSC helpers from DP helpers.
- Clang build fixes for drm/mm test.
- Remove simple pipeline support for gem-vram,
  no longer any users left after converting bochs.
- Add erno to drm_sched_start to distinguish between GPU and queue
  reset.
- Add drm_framebuffer testcases.
- Fix uninitialized spinlock acquisition with CONFIG_DRM_PANIC=n.
- Use read_trylock instead of read_lock in dma_fence_begin_signalling to
  quiesce lockdep.

Driver Changes:
- Assorted small fixes and updates for tegra, host1x, imagination,
  nouveau, panfrost, panthor, panel/ili9341, mali, exynos,
  panel/samsung-s6e3fa7, ast, bridge/ti-sn65dsi86, panel/himax-hx83112a,
  bridge/tc358767, bridge/imx8mp-hdmi-tx, panel/khadas-ts050,
  panel/nt36523, panel/sony-acx565akm, kmb, accel/qaic, omap, v3d.
- Add bridge/TI TDP158.
- Assorted documentation updates.
- Convert bochs from simple drm to gem shmem, and check modes
  against available memory.
- Many VC4 fixes, most related to scaling and YUV support.
- Convert some drivers to use SYSTEM_SLEEP_PM_OPS and RUNTIME_PM_OPS.
- Rockchip 4k@60 support.

Signed-off-by: Dave Airlie <airlied@redhat.com>
From: Maarten Lankhorst <maarten.lankhorst@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/445713a6-2427-4c53-8ec2-3a894ec62405@linux.intel.com

Author: airlied

Documentation/devicetree/bindings/display/bridge/ti,tdp158.yaml

@@ -0,0 +1,57 @@
+# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/display/bridge/ti,tdp158.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: TI TDP158 HDMI to TMDS Redriver
+
+maintainers:
+  - Arnaud Vrac <avrac@freebox.fr>
+  - Pierre-Hugues Husson <phhusson@freebox.fr>
+
+properties:
+  compatible:
+    const: ti,tdp158
+
+# The reg property is required if and only if the device is connected
+# to an I2C bus. In pin strap mode, reg must not be specified.
+  reg:
+    description: I2C address of the device
+
+# Pin 36 = Operation Enable / Reset Pin
+# OE = L: Power Down Mode
+# OE = H: Normal Operation
+# Internal weak pullup - device resets on H to L transitions
+  enable-gpios:
+    description: GPIO controlling bridge enable
+
+  vcc-supply:
+    description: Power supply 3.3V
+
+  vdd-supply:
+    description: Power supply 1.1V
+
+  ports:
+    $ref: /schemas/graph.yaml#/properties/ports
+
+    properties:
+      port@0:
+        $ref: /schemas/graph.yaml#/properties/port
+        description: Bridge input
+
+      port@1:
+        $ref: /schemas/graph.yaml#/properties/port
+        description: Bridge output
+
+    required:
+      - port@0
+      - port@1
+
+required:
+  - compatible
+  - vcc-supply
+  - vdd-supply
+  - ports
+
+additionalProperties: false

Documentation/devicetree/bindings/display/imx/fsl-imx-drm.txt

@@ -119,7 +119,6 @@ Optional properties:
 - interface-pix-fmt: How this display is connected to the
   display interface. Currently supported types: "rgb24", "rgb565", "bgr666"
   and "lvds666".
-- edid: verbatim EDID data block describing attached display.
 - ddc: phandle describing the i2c bus handling the display data
   channel
 - port@[0-1]: Port nodes with endpoint definitions as defined in
@@ -131,7 +130,6 @@ example:
 
 disp0 {
 	compatible = "fsl,imx-parallel-display";
-	edid = [edid-data];
 	interface-pix-fmt = "rgb24";
 
 	port@0 {

Documentation/devicetree/bindings/display/imx/ldb.txt

@@ -62,7 +62,6 @@ Required properties:
    display-timings are used instead.
 
 Optional properties (required if display-timings are used):
- - ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing
  - display-timings : A node that describes the display timings as defined in
    Documentation/devicetree/bindings/display/panel/display-timing.txt.
  - fsl,data-mapping : should be "spwg" or "jeida"

Documentation/devicetree/bindings/gpu/arm,mali-bifrost.yaml

@@ -26,6 +26,7 @@ properties:
               - renesas,r9a07g054-mali
               - rockchip,px30-mali
               - rockchip,rk3568-mali
+              - rockchip,rk3576-mali
           - const: arm,mali-bifrost # Mali Bifrost GPU model/revision is fully discoverable
       - items:
           - enum:

Documentation/gpu/drm-uapi.rst

@@ -305,13 +305,26 @@ Kernel Mode Driver
 ------------------
 
 The KMD is responsible for checking if the device needs a reset, and to perform
-it as needed. Usually a hang is detected when a job gets stuck executing. KMD
-should keep track of resets, because userspace can query any time about the
-reset status for a specific context. This is needed to propagate to the rest of
-the stack that a reset has happened. Currently, this is implemented by each
-driver separately, with no common DRM interface. Ideally this should be properly
-integrated at DRM scheduler to provide a common ground for all drivers. After a
-reset, KMD should reject new command submissions for affected contexts.
+it as needed. Usually a hang is detected when a job gets stuck executing.
+
+Propagation of errors to userspace has proven to be tricky since it goes in
+the opposite direction of the usual flow of commands. Because of this vendor
+independent error handling was added to the &dma_fence object, this way drivers
+can add an error code to their fences before signaling them. See function
+dma_fence_set_error() on how to do this and for examples of error codes to use.
+
+The DRM scheduler also allows setting error codes on all pending fences when
+hardware submissions are restarted after an reset. Error codes are also
+forwarded from the hardware fence to the scheduler fence to bubble up errors
+to the higher levels of the stack and eventually userspace.
+
+Fence errors can be queried by userspace through the generic SYNC_IOC_FILE_INFO
+IOCTL as well as through driver specific interfaces.
+
+Additional to setting fence errors drivers should also keep track of resets per
+context, the DRM scheduler provides the drm_sched_entity_error() function as
+helper for this use case. After a reset, KMD should reject new command
+submissions for affected contexts.
 
 User Mode Driver
 ----------------

Documentation/gpu/todo.rst

@@ -834,6 +834,22 @@ Contact: Javier Martinez Canillas <javierm@redhat.com>
 
 Level: Advanced
 
+Querying errors from drm_syncobj
+================================
+
+The drm_syncobj container can be used by driver independent code to signal
+complection of submission.
+
+One minor feature still missing is a generic DRM IOCTL to query the error
+status of binary and timeline drm_syncobj.
+
+This should probably be improved by implementing the necessary kernel interface
+and adding support for that in the userspace stack.
+
+Contact: Christian König
+
+Level: Starter
+
 Outside DRM
 ===========
 

drivers/accel/qaic/qaic_debugfs.c

@@ -64,41 +64,19 @@ static int bootlog_show(struct seq_file *s, void *unused)
 	return 0;
 }
 
-static int bootlog_fops_open(struct inode *inode, struct file *file)
-{
-	return single_open(file, bootlog_show, inode->i_private);
-}
-
-static const struct file_operations bootlog_fops = {
-	.owner = THIS_MODULE,
-	.open = bootlog_fops_open,
-	.read = seq_read,
-	.llseek = seq_lseek,
-	.release = single_release,
-};
+DEFINE_SHOW_ATTRIBUTE(bootlog);
 
-static int read_dbc_fifo_size(struct seq_file *s, void *unused)
+static int fifo_size_show(struct seq_file *s, void *unused)
 {
 	struct dma_bridge_chan *dbc = s->private;
 
 	seq_printf(s, "%u\n", dbc->nelem);
 	return 0;
 }
 
-static int fifo_size_open(struct inode *inode, struct file *file)
-{
-	return single_open(file, read_dbc_fifo_size, inode->i_private);
-}
-
-static const struct file_operations fifo_size_fops = {
-	.owner = THIS_MODULE,
-	.open = fifo_size_open,
-	.read = seq_read,
-	.llseek = seq_lseek,
-	.release = single_release,
-};
+DEFINE_SHOW_ATTRIBUTE(fifo_size);
 
-static int read_dbc_queued(struct seq_file *s, void *unused)
+static int queued_show(struct seq_file *s, void *unused)
 {
 	struct dma_bridge_chan *dbc = s->private;
 	u32 tail = 0, head = 0;
@@ -115,18 +93,7 @@ static int read_dbc_queued(struct seq_file *s, void *unused)
 	return 0;
 }
 
-static int queued_open(struct inode *inode, struct file *file)
-{
-	return single_open(file, read_dbc_queued, inode->i_private);
-}
-
-static const struct file_operations queued_fops = {
-	.owner = THIS_MODULE,
-	.open = queued_open,
-	.read = seq_read,
-	.llseek = seq_lseek,
-	.release = single_release,
-};
+DEFINE_SHOW_ATTRIBUTE(queued);
 
 void qaic_debugfs_init(struct qaic_drm_device *qddev)
 {

drivers/dma-buf/dma-fence.c

@@ -309,8 +309,8 @@ bool dma_fence_begin_signalling(void)
 	if (in_atomic())
 		return true;
 
-	/* ... and non-recursive readlock */
-	lock_acquire(&dma_fence_lockdep_map, 0, 0, 1, 1, NULL, _RET_IP_);
+	/* ... and non-recursive successful read_trylock */
+	lock_acquire(&dma_fence_lockdep_map, 0, 1, 1, 1, NULL, _RET_IP_);
 
 	return false;
 }
@@ -341,7 +341,7 @@ void __dma_fence_might_wait(void)
 	lock_map_acquire(&dma_fence_lockdep_map);
 	lock_map_release(&dma_fence_lockdep_map);
 	if (tmp)
-		lock_acquire(&dma_fence_lockdep_map, 0, 0, 1, 1, NULL, _THIS_IP_);
+		lock_acquire(&dma_fence_lockdep_map, 0, 1, 1, 1, NULL, _THIS_IP_);
 }
 #endif
 

drivers/dma-buf/heaps/cma_heap.c

@@ -366,7 +366,7 @@ static const struct dma_heap_ops cma_heap_ops = {
 	.allocate = cma_heap_allocate,
 };
 
-static int __add_cma_heap(struct cma *cma, void *data)
+static int __init __add_cma_heap(struct cma *cma, void *data)
 {
 	struct cma_heap *cma_heap;
 	struct dma_heap_export_info exp_info;
@@ -391,7 +391,7 @@ static int __add_cma_heap(struct cma *cma, void *data)
 	return 0;
 }
 
-static int add_default_cma_heap(void)
+static int __init add_default_cma_heap(void)
 {
 	struct cma *default_cma = dev_get_cma_area(NULL);
 	int ret = 0;

drivers/dma-buf/heaps/system_heap.c

@@ -421,7 +421,7 @@ static const struct dma_heap_ops system_heap_ops = {
 	.allocate = system_heap_allocate,
 };
 
-static int system_heap_create(void)
+static int __init system_heap_create(void)
 {
 	struct dma_heap_export_info exp_info;