spi: cadence-quadspi: Use BIT() macros where possible

Convert few open coded bit shifts to BIT() macro for better readability.
No functional changes intended.

Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Signed-off-by: Santhosh Kumar K <s-k6@ti.com>
Message-ID: <20250905185958.3575037-5-s-k6@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Author: r-vignesh

drivers/spi/spi-cadence-quadspi.c

@@ -335,7 +335,7 @@ static bool cqspi_is_idle(struct cqspi_st *cqspi)
 {
 	u32 reg = readl(cqspi->iobase + CQSPI_REG_CONFIG);
 
-	return reg & (1UL << CQSPI_REG_CONFIG_IDLE_LSB);
+	return reg & BIT(CQSPI_REG_CONFIG_IDLE_LSB);
 }
 
 static u32 cqspi_get_rd_sram_level(struct cqspi_st *cqspi)
@@ -571,15 +571,15 @@ static int cqspi_command_read(struct cqspi_flash_pdata *f_pdata,
 		reg |= (dummy_clk & CQSPI_REG_CMDCTRL_DUMMY_MASK)
 		     << CQSPI_REG_CMDCTRL_DUMMY_LSB;
 
-	reg |= (0x1 << CQSPI_REG_CMDCTRL_RD_EN_LSB);
+	reg |= BIT(CQSPI_REG_CMDCTRL_RD_EN_LSB);
 
 	/* 0 means 1 byte. */
 	reg |= (((n_rx - 1) & CQSPI_REG_CMDCTRL_RD_BYTES_MASK)
 		<< CQSPI_REG_CMDCTRL_RD_BYTES_LSB);
 
 	/* setup ADDR BIT field */
 	if (op->addr.nbytes) {
-		reg |= (0x1 << CQSPI_REG_CMDCTRL_ADDR_EN_LSB);
+		reg |= BIT(CQSPI_REG_CMDCTRL_ADDR_EN_LSB);
 		reg |= ((op->addr.nbytes - 1) &
 			CQSPI_REG_CMDCTRL_ADD_BYTES_MASK)
 			<< CQSPI_REG_CMDCTRL_ADD_BYTES_LSB;
@@ -646,7 +646,7 @@ static int cqspi_command_write(struct cqspi_flash_pdata *f_pdata,
 	reg = opcode << CQSPI_REG_CMDCTRL_OPCODE_LSB;
 
 	if (op->addr.nbytes) {
-		reg |= (0x1 << CQSPI_REG_CMDCTRL_ADDR_EN_LSB);
+		reg |= BIT(CQSPI_REG_CMDCTRL_ADDR_EN_LSB);
 		reg |= ((op->addr.nbytes - 1) &
 			CQSPI_REG_CMDCTRL_ADD_BYTES_MASK)
 			<< CQSPI_REG_CMDCTRL_ADD_BYTES_LSB;
@@ -655,7 +655,7 @@ static int cqspi_command_write(struct cqspi_flash_pdata *f_pdata,
 	}
 
 	if (n_tx) {
-		reg |= (0x1 << CQSPI_REG_CMDCTRL_WR_EN_LSB);
+		reg |= BIT(CQSPI_REG_CMDCTRL_WR_EN_LSB);
 		reg |= ((n_tx - 1) & CQSPI_REG_CMDCTRL_WR_BYTES_MASK)
 			<< CQSPI_REG_CMDCTRL_WR_BYTES_LSB;
 		data = 0;
@@ -1191,7 +1191,7 @@ static void cqspi_chipselect(struct cqspi_flash_pdata *f_pdata)
 		 * CS2 to 4b'1011
 		 * CS3 to 4b'0111
 		 */
-		chip_select = 0xF & ~(1 << chip_select);
+		chip_select = 0xF & ~BIT(chip_select);
 	}
 
 	reg &= ~(CQSPI_REG_CONFIG_CHIPSELECT_MASK
@@ -1277,9 +1277,9 @@ static void cqspi_readdata_capture(struct cqspi_st *cqspi,
 	reg = readl(reg_base + CQSPI_REG_READCAPTURE);
 
 	if (bypass)
-		reg |= (1 << CQSPI_REG_READCAPTURE_BYPASS_LSB);
+		reg |= BIT(CQSPI_REG_READCAPTURE_BYPASS_LSB);
 	else
-		reg &= ~(1 << CQSPI_REG_READCAPTURE_BYPASS_LSB);
+		reg &= ~BIT(CQSPI_REG_READCAPTURE_BYPASS_LSB);
 
 	reg &= ~(CQSPI_REG_READCAPTURE_DELAY_MASK
 		 << CQSPI_REG_READCAPTURE_DELAY_LSB);