serial: 8250_dw: Do not reclock if already at correct rate

When userspace opens the console, we call set_termios() passing a
termios with the console's configured baud rate. Currently this causes
dw8250_set_termios() to disable and then re-enable the UART clock at
the same frequency as it was originally. This can cause corruption
of any concurrent console output. Fix it by skipping the reclocking
if we are already at the correct rate.

Signed-off-by: Peter Collingbourne <pcc@google.com>
Fixes: 4e26b13 ("serial: 8250_dw: clock rate handling for all ACPI platforms")
Cc: stable@vger.kernel.org
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Link: https://lore.kernel.org/r/20240222192635.1050502-1-pcc@google.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Author: pcc

drivers/tty/serial/8250/8250_dw.c

@@ -357,18 +357,18 @@ static void dw8250_set_termios(struct uart_port *p, struct ktermios *termios,
 	long rate;
 	int ret;
 
-	clk_disable_unprepare(d->clk);
 	rate = clk_round_rate(d->clk, newrate);
-	if (rate > 0) {
+	if (rate > 0 && p->uartclk != rate) {
+		clk_disable_unprepare(d->clk);
 		/*
 		 * Note that any clock-notifer worker will block in
 		 * serial8250_update_uartclk() until we are done.
 		 */
 		ret = clk_set_rate(d->clk, newrate);
 		if (!ret)
 			p->uartclk = rate;
+		clk_prepare_enable(d->clk);
 	}
-	clk_prepare_enable(d->clk);
 
 	dw8250_do_set_termios(p, termios, old);
 }