arm64: dts: imx8qm-mek: fix mux-controller select/enable-gpios polarity

According to the board design, set SEL to high means flipped
connection (TX2/RX2). And the TCPM will output logical 1 if it needs
flipped connection. So switch to active high for select-gpios.
The EN pin on mux chip is low active, so switch to active low for
enable-gpios too.

Fixes: b237975 ("arm64: dts: imx8qm-mek: add usb 3.0 and related type C nodes")
Cc: stable@vger.kernel.org
Reviewed-by: Jun Li <jun.li@nxp.com>
Signed-off-by: Xu Yang <xu.yang_2@nxp.com>
Reviewed-by: Frank Li <Frank.Li@nxp.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

Author: Xu Yang

arch/arm64/boot/dts/freescale/imx8qm-mek.dts

@@ -217,8 +217,8 @@
 		compatible = "nxp,cbdtu02043", "gpio-sbu-mux";
 		pinctrl-names = "default";
 		pinctrl-0 = <&pinctrl_typec_mux>;
-		select-gpios = <&lsio_gpio4 6 GPIO_ACTIVE_LOW>;
-		enable-gpios = <&lsio_gpio4 19 GPIO_ACTIVE_HIGH>;
+		select-gpios = <&lsio_gpio4 6 GPIO_ACTIVE_HIGH>;
+		enable-gpios = <&lsio_gpio4 19 GPIO_ACTIVE_LOW>;
 		orientation-switch;
 
 		port {