Bluetooth: hci_qca: make pwrseq calls the default if available

If the device has a power sequencing handle, use it first. Otherwise
fall back to whatever code already exists.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>

Author: Bartosz Golaszewski

drivers/bluetooth/hci_qca.c

@@ -1718,6 +1718,7 @@ static int qca_regulator_init(struct hci_uart *hu)
 	 * off the voltage regulator.
 	 */
 	qcadev = serdev_device_get_drvdata(hu->serdev);
+
 	if (!qcadev->bt_power->vregs_on) {
 		serdev_device_close(hu->serdev);
 		ret = qca_regulator_enable(qcadev);
@@ -1800,18 +1801,8 @@ static int qca_power_on(struct hci_dev *hdev)
 	case QCA_WCN6750:
 	case QCA_WCN6855:
 	case QCA_WCN7850:
-		ret = qca_regulator_init(hu);
-		break;
-
 	case QCA_QCA6390:
-		qcadev = serdev_device_get_drvdata(hu->serdev);
-		ret = pwrseq_power_on(qcadev->bt_power->pwrseq);
-		if (ret)
-			return ret;
-
-		ret = qca_port_reopen(hu);
-		if (ret)
-			return ret;
+		ret = qca_regulator_init(hu);
 		break;
 
 	default:
@@ -2149,6 +2140,7 @@ static void qca_power_shutdown(struct hci_uart *hu)
 	unsigned long flags;
 	enum qca_btsoc_type soc_type = qca_soc_type(hu);
 	bool sw_ctrl_state;
+	struct qca_power *power;
 
 	/* From this point we go into power off state. But serial port is
 	 * still open, stop queueing the IBS data and flush all the buffered
@@ -2166,6 +2158,13 @@ static void qca_power_shutdown(struct hci_uart *hu)
 		return;
 
 	qcadev = serdev_device_get_drvdata(hu->serdev);
+	power = qcadev->bt_power;
+
+	if (power->pwrseq) {
+		pwrseq_power_off(power->pwrseq);
+		set_bit(QCA_BT_OFF, &qca->flags);
+		return;
+        }
 
 	switch (soc_type) {
 	case QCA_WCN3988:
@@ -2227,6 +2226,9 @@ static int qca_regulator_enable(struct qca_serdev *qcadev)
 	struct qca_power *power = qcadev->bt_power;
 	int ret;
 
+	if (power->pwrseq)
+		return pwrseq_power_on(power->pwrseq);
+
 	/* Already enabled */
 	if (power->vregs_on)
 		return 0;