ARM: dts: qcom: apq8026: remove superfluous "input-enable"

Pin configuration property "input-enable" was used with the intention to
disable the output, but this is done by default by Linux drivers.  Since
patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
input-enable") the property is not accepted anymore.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20230410181005.25853-1-krzysztof.kozlowski@linaro.org

Author: krzk

arch/arm/boot/dts/qcom-apq8026-asus-sparrow.dts

@@ -268,15 +268,13 @@
 		function = "gpio";
 		drive-strength = <8>;
 		bias-disable;
-		input-enable;
 	};
 
 	wlan_hostwake_default_state: wlan-hostwake-default-state {
 		pins = "gpio46";
 		function = "gpio";
 		drive-strength = <2>;
 		bias-disable;
-		input-enable;
 	};
 
 	wlan_regulator_default_state: wlan-regulator-default-state {

arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts

@@ -352,7 +352,6 @@
 		function = "gpio";
 		drive-strength = <2>;
 		bias-disable;
-		input-enable;
 	};
 
 	wlan_regulator_default_state: wlan-regulator-default-state {

arch/arm/boot/dts/qcom-apq8026-lg-lenok.dts

@@ -307,7 +307,6 @@
 		function = "gpio";
 		drive-strength = <2>;
 		bias-disable;
-		input-enable;
 	};
 
 	touch_pins: touch-state {
@@ -317,7 +316,6 @@
 
 			drive-strength = <8>;
 			bias-pull-down;
-			input-enable;
 		};
 
 		reset-pins {
@@ -335,7 +333,6 @@
 		function = "gpio";
 		drive-strength = <2>;
 		bias-disable;
-		input-enable;
 	};
 
 	wlan_regulator_default_state: wlan-regulator-default-state {