dpaa2-switch: set interface MAC address only on endpoint change

There is no point in updating the MAC address of a switch interface each
time the link state changes, this only needs to happen in case the
endpoint changes (the switch interface is [dis]connected from/to a MAC).

Just move the call to dpaa2_switch_port_set_mac_addr() under
DPSW_IRQ_EVENT_ENDPOINT_CHANGED.

Reviewed-by: Simon Horman <horms@kernel.org>
Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Author: IoanaCiornei

drivers/net/ethernet/freescale/dpaa2/dpaa2-switch.c

@@ -1523,12 +1523,11 @@ static irqreturn_t dpaa2_switch_irq0_handler_thread(int irq_num, void *arg)
 	if_id = (status & 0xFFFF0000) >> 16;
 	port_priv = ethsw->ports[if_id];
 
-	if (status & DPSW_IRQ_EVENT_LINK_CHANGED) {
+	if (status & DPSW_IRQ_EVENT_LINK_CHANGED)
 		dpaa2_switch_port_link_state_update(port_priv->netdev);
-		dpaa2_switch_port_set_mac_addr(port_priv);
-	}
 
 	if (status & DPSW_IRQ_EVENT_ENDPOINT_CHANGED) {
+		dpaa2_switch_port_set_mac_addr(port_priv);
 		/* We can avoid locking because the "endpoint changed" IRQ
 		 * handler is the only one who changes priv->mac at runtime,
 		 * so we are not racing with anyone.