riscv: dts: starfive: jh7110-common: qspi flash setting read-delay 2 cycles max 100MHz

Use qspi flash read-delay and spi-max-frequency settings compatible with
U-Boot bootloader.

Observations from testing on Pine64 Star64 hardware within U-Boot bootloader
and read-delay=2 are spi-max-frequency less than 49.8MHz fails to write,
corrupt data writes at 25MHz to 49.799999MHz, and valid data writes at
49.8MHz to 100MHz (not tested above 100MHz). No valid spi-max-frequency
was found for 1<read-delay<=3 and corrupt data with read-delay=3.

Looking around the Linux codebase it is common to see read-delay 2 cycles
with spi-max-frequency 100MHz and testing confirms this to work in both
U-Boot and Linux.

Signed-off-by: E Shattow <e@freeshell.de>
Reviewed-by: Hal Feng <hal.feng@starfivetech.com>
Acked-by: Emil Renner Berthing <emil.renner.berthing@canonical.com>
Signed-off-by: Conor Dooley <conor.dooley@microchip.com>

Author: E Shattow

arch/riscv/boot/dts/starfive/jh7110-common.dtsi

@@ -318,8 +318,8 @@
 	nor_flash: flash@0 {
 		compatible = "jedec,spi-nor";
 		reg = <0>;
-		cdns,read-delay = <5>;
-		spi-max-frequency = <12000000>;
+		cdns,read-delay = <2>;
+		spi-max-frequency = <100000000>;
 		cdns,tshsl-ns = <1>;
 		cdns,tsd2d-ns = <1>;
 		cdns,tchsh-ns = <1>;