soc: ti: Use of_property_read_bool() for boolean properties

It is preferred to use typed property access functions (i.e.
of_property_read_<type> functions) rather than low-level
of_get_property/of_find_property functions for reading properties.
Convert reading boolean properties to of_property_read_bool().

Signed-off-by: Rob Herring <robh@kernel.org>
Signed-off-by: Nishanth Menon <nm@ti.com>
Link: https://lore.kernel.org/r/20230310144726.1545453-1-robh@kernel.org

Author: robherring

drivers/soc/ti/knav_dma.c

@@ -666,8 +666,8 @@ static int dma_init(struct device_node *cloud, struct device_node *dma_node)
 	dma->rx_priority = DMA_PRIO_DEFAULT;
 	dma->tx_priority = DMA_PRIO_DEFAULT;
 
-	dma->enable_all	= (of_get_property(node, "ti,enable-all", NULL) != NULL);
-	dma->loopback	= (of_get_property(node, "ti,loop-back",  NULL) != NULL);
+	dma->enable_all	= of_property_read_bool(node, "ti,enable-all");
+	dma->loopback	= of_property_read_bool(node, "ti,loop-back");
 
 	ret = of_property_read_u32(node, "ti,rx-retry-timeout", &timeout);
 	if (ret < 0) {

drivers/soc/ti/knav_qmss_acc.c

@@ -521,7 +521,7 @@ int knav_init_acc_range(struct knav_device *kdev,
 
 	info->pdsp = pdsp;
 	channels = range->num_queues;
-	if (of_get_property(node, "multi-queue", NULL)) {
+	if (of_property_read_bool(node, "multi-queue")) {
 		range->flags |= RANGE_MULTI_QUEUE;
 		channels = 1;
 		if (range->queue_base & (32 - 1)) {

drivers/soc/ti/knav_qmss_queue.c

@@ -1264,7 +1264,7 @@ static int knav_setup_queue_range(struct knav_device *kdev,
 	if (range->num_irqs)
 		range->flags |= RANGE_HAS_IRQ;
 
-	if (of_get_property(node, "qalloc-by-id", NULL))
+	if (of_property_read_bool(node, "qalloc-by-id"))
 		range->flags |= RANGE_RESERVED;
 
 	if (of_property_present(node, "accumulator")) {

drivers/soc/ti/wkup_m3_ipc.c

@@ -681,7 +681,7 @@ static int wkup_m3_ipc_probe(struct platform_device *pdev)
 			dev_warn(dev, "Invalid VTT GPIO(%d) pin\n", temp);
 	}
 
-	if (of_find_property(np, "ti,set-io-isolation", NULL))
+	if (of_property_read_bool(np, "ti,set-io-isolation"))
 		wkup_m3_set_io_isolation(m3_ipc);
 
 	ret = of_property_read_string(np, "firmware-name",