scsi: megaraid_sas: Block zero-length ATA VPD inquiry

A firmware bug was observed where ATA VPD inquiry commands with a
zero-length data payload were not handled and failed with a non-standard
status code of 0xf0.

Avoid sending ATA VPD inquiry commands without data payload by setting
the device no_vpd_size flag to 1. In addition, if the firmware returns a
status code of 0xf0, set scsi_cmnd->result to CHECK_CONDITION to
facilitate proper error handling.

Suggested-by: Martin K. Petersen <martin.petersen@oracle.com>
Signed-off-by: Chandrakanth Patil <chandrakanth.patil@broadcom.com>
Cc: stable@vger.kernel.org
Link: https://lore.kernel.org/r/20250402193735.5098-1-chandrakanth.patil@broadcom.com
Tested-by: Ryan Lahfa <ryan@lahfa.xyz>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

Author: cp890582

drivers/scsi/megaraid/megaraid_sas_base.c

@@ -2103,6 +2103,9 @@ static int megasas_sdev_configure(struct scsi_device *sdev,
 	/* This sdev property may change post OCR */
 	megasas_set_dynamic_target_properties(sdev, lim, is_target_prop);
 
+	if (!MEGASAS_IS_LOGICAL(sdev))
+		sdev->no_vpd_size = 1;
+
 	mutex_unlock(&instance->reset_mutex);
 
 	return 0;
@@ -3662,8 +3665,10 @@ megasas_complete_cmd(struct megasas_instance *instance, struct megasas_cmd *cmd,
 
 		case MFI_STAT_SCSI_IO_FAILED:
 		case MFI_STAT_LD_INIT_IN_PROGRESS:
-			cmd->scmd->result =
-			    (DID_ERROR << 16) | hdr->scsi_status;
+			if (hdr->scsi_status == 0xf0)
+				cmd->scmd->result = (DID_ERROR << 16) | SAM_STAT_CHECK_CONDITION;
+			else
+				cmd->scmd->result = (DID_ERROR << 16) | hdr->scsi_status;
 			break;
 
 		case MFI_STAT_SCSI_DONE_WITH_ERROR:

drivers/scsi/megaraid/megaraid_sas_fusion.c

@@ -2043,7 +2043,10 @@ map_cmd_status(struct fusion_context *fusion,
 
 	case MFI_STAT_SCSI_IO_FAILED:
 	case MFI_STAT_LD_INIT_IN_PROGRESS:
-		scmd->result = (DID_ERROR << 16) | ext_status;
+		if (ext_status == 0xf0)
+			scmd->result = (DID_ERROR << 16) | SAM_STAT_CHECK_CONDITION;
+		else
+			scmd->result = (DID_ERROR << 16) | ext_status;
 		break;
 
 	case MFI_STAT_SCSI_DONE_WITH_ERROR: