Revert "regulator: pca9450: Add SD_VSEL GPIO for LDO5"

This reverts commit 8c67a11.

It turns out that all boards using the PCA9450 actually have the
SD_VSEL input connected to the VSELECT signal of the SoCs SD/MMC
interface or use a fixed level.

The assumptions on which this was implemented were wrong. There
is no need for a GPIO-only-based approach and keeping this will
cause confusion and lead people to implement non-standard setups.

All in-tree users of this have been migrated and we can savely
remove this now and allow for a more future-proof approach
of syncing the actual status of SD_VSEL and the PMIC driver.

Signed-off-by: Frieder Schrempf <frieder.schrempf@kontron.de>
Link: https://patch.msgid.link/20241218152842.97483-4-frieder@fris.de
Signed-off-by: Mark Brown <broonie@kernel.org>

Author: fschrempf

drivers/regulator/pca9450-regulator.c

@@ -5,7 +5,6 @@
  */
 
 #include <linux/err.h>
-#include <linux/gpio/consumer.h>
 #include <linux/i2c.h>
 #include <linux/interrupt.h>
 #include <linux/kernel.h>
@@ -32,7 +31,6 @@ struct pca9450_regulator_desc {
 struct pca9450 {
 	struct device *dev;
 	struct regmap *regmap;
-	struct gpio_desc *sd_vsel_gpio;
 	enum pca9450_chip_type type;
 	unsigned int rcnt;
 	int irq;
@@ -1031,17 +1029,6 @@ static int pca9450_i2c_probe(struct i2c_client *i2c)
 					     "Failed to enable I2C level translator\n");
 	}
 
-	/*
-	 * The driver uses the LDO5CTRL_H register to control the LDO5 regulator.
-	 * This is only valid if the SD_VSEL input of the PMIC is high. Let's
-	 * check if the pin is available as GPIO and set it to high.
-	 */
-	pca9450->sd_vsel_gpio = gpiod_get_optional(pca9450->dev, "sd-vsel", GPIOD_OUT_HIGH);
-
-	if (IS_ERR(pca9450->sd_vsel_gpio))
-		return dev_err_probe(&i2c->dev, PTR_ERR(pca9450->sd_vsel_gpio),
-				     "Failed to get SD_VSEL GPIO\n");
-
 	dev_info(&i2c->dev, "%s probed.\n",
 		type == PCA9450_TYPE_PCA9450A ? "pca9450a" :
 		(type == PCA9450_TYPE_PCA9451A ? "pca9451a" : "pca9450bc"));