xfrm: Linearize the skb after offloading if needed.

With offloading enabled, esp_xmit() gets invoked very late, from within
validate_xmit_xfrm() which is after validate_xmit_skb() validates and
linearizes the skb if the underlying device does not support fragments.

esp_output_tail() may add a fragment to the skb while adding the auth
tag/ IV. Devices without the proper support will then send skb->data
points to with the correct length so the packet will have garbage at the
end. A pcap sniffer will claim that the proper data has been sent since
it parses the skb properly.

It is not affected with INET_ESP_OFFLOAD disabled.

Linearize the skb after offloading if the sending hardware requires it.
It was tested on v4, v6 has been adopted.

Fixes: 7785bba ("esp: Add a software GRO codepath")
Signed-off-by: Sebastian Andrzej Siewior <bigeasy@linutronix.de>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>

Author: Sebastian Andrzej Siewior

net/ipv4/esp4_offload.c

@@ -340,6 +340,9 @@ static int esp_xmit(struct xfrm_state *x, struct sk_buff *skb,  netdev_features_
 
 	secpath_reset(skb);
 
+	if (skb_needs_linearize(skb, skb->dev->features) &&
+	    __skb_linearize(skb))
+		return -ENOMEM;
 	return 0;
 }
 

net/ipv6/esp6_offload.c

@@ -374,6 +374,9 @@ static int esp6_xmit(struct xfrm_state *x, struct sk_buff *skb,  netdev_features
 
 	secpath_reset(skb);
 
+	if (skb_needs_linearize(skb, skb->dev->features) &&
+	    __skb_linearize(skb))
+		return -ENOMEM;
 	return 0;
 }