leds: leds-lp50xx: Allow LED 0 to be added to module bank

led_banks contains LED module number(s) that should be grouped into the
module bank. led_banks is 0-initialized.
By checking the led_banks entries for 0, un-set entries are detected.
But a 0-entry also indicates that LED module 0 should be grouped into the
module bank.

By only iterating over the available entries no check for unused entries
is required and LED module 0 can be added to bank.

Cc: stable@vger.kernel.org
Fixes: 242b811 ("leds: lp50xx: Add the LP50XX family of the RGB LED driver")
Signed-off-by: Christian Hitz <christian.hitz@bbv.ch>
Reviewed-by: Jacek Anaszewski <jacek.anaszewski@gmail.com>
Link: https://patch.msgid.link/20251008123222.1117331-1-christian@klarinett.li
Signed-off-by: Lee Jones <lee@kernel.org>

Author: chhitz

drivers/leds/leds-lp50xx.c

@@ -341,17 +341,15 @@ static int lp50xx_brightness_set(struct led_classdev *cdev,
 	return ret;
 }
 
-static int lp50xx_set_banks(struct lp50xx *priv, u32 led_banks[])
+static int lp50xx_set_banks(struct lp50xx *priv, u32 led_banks[], int num_leds)
 {
 	u8 led_config_lo, led_config_hi;
 	u32 bank_enable_mask = 0;
 	int ret;
 	int i;
 
-	for (i = 0; i < priv->chip_info->max_modules; i++) {
-		if (led_banks[i])
-			bank_enable_mask |= (1 << led_banks[i]);
-	}
+	for (i = 0; i < num_leds; i++)
+		bank_enable_mask |= (1 << led_banks[i]);
 
 	led_config_lo = bank_enable_mask;
 	led_config_hi = bank_enable_mask >> 8;
@@ -405,7 +403,7 @@ static int lp50xx_probe_leds(struct fwnode_handle *child, struct lp50xx *priv,
 			return ret;
 		}
 
-		ret = lp50xx_set_banks(priv, led_banks);
+		ret = lp50xx_set_banks(priv, led_banks, num_leds);
 		if (ret) {
 			dev_err(priv->dev, "Cannot setup banked LEDs\n");
 			return ret;