docs: gpio: prefer pread(2) for interrupt reading

In legacy sysfs GPIO, when using poll(2) on the sysfs GPIO value for
state change awaiting, a subsequent read(2) is required for consuming
the event, which the doc recommends the use of lseek(2) or
close-and-reopen to reset the file offset afterwards.

The recommendations however, require at least 2 syscalls to consume
the event. Gladly, use of pread(2) require only 1 syscall for the
consumption. Let's advertise this usage by prioritizing its placement.

Signed-off-by: Huichun Feng <foxhoundsk.tw@gmail.com>
Link: https://lore.kernel.org/r/20240609173728.2950808-1-foxhoundsk.tw@gmail.com
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

Author: foxhoundsk

Documentation/userspace-api/gpio/sysfs.rst

@@ -97,9 +97,10 @@ and have the following read/write attributes:
 		poll(2) will return whenever the interrupt was triggered. If
 		you use poll(2), set the events POLLPRI and POLLERR. If you
 		use select(2), set the file descriptor in exceptfds. After
-		poll(2) returns, either lseek(2) to the beginning of the sysfs
-		file and read the new value or close the file and re-open it
-		to read the value.
+		poll(2) returns, use pread(2) to read the value at offset
+		zero. Alternatively, either lseek(2) to the beginning of the
+		sysfs file and read the new value or close the file and
+		re-open it to read the value.
 
 	"edge" ...
 		reads as either "none", "rising", "falling", or