drm/bridge: anx7625: change the gpiod_set_value API

Use gpiod_set_value_cansleep() instead of gpiod_set_value()
to fix the below call trace in the boot log:

[    5.690534] Call trace:
[    5.690536]  gpiod_set_value+0x40/0xa4
[    5.690540]  anx7625_runtime_pm_resume+0xa0/0x324 [anx7625]
[    5.690545]  __rpm_callback+0x48/0x1d8
[    5.690549]  rpm_callback+0x6c/0x78

Certain GPIO controllers require access via message-based buses
such as I2C or SPI, which may cause the GPIOs to enter a sleep
state. Therefore, use the gpiod_set_value_cansleep().

Signed-off-by: Ayushi Makhija <quic_amakhija@quicinc.com>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Link: https://lore.kernel.org/r/20250505094245.2660750-7-quic_amakhija@quicinc.com
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>

Author: Ayushi Makhija

drivers/gpu/drm/bridge/analogix/anx7625.c

@@ -1257,10 +1257,10 @@ static void anx7625_power_on(struct anx7625_data *ctx)
 	usleep_range(11000, 12000);
 
 	/* Power on pin enable */
-	gpiod_set_value(ctx->pdata.gpio_p_on, 1);
+	gpiod_set_value_cansleep(ctx->pdata.gpio_p_on, 1);
 	usleep_range(10000, 11000);
 	/* Power reset pin enable */
-	gpiod_set_value(ctx->pdata.gpio_reset, 1);
+	gpiod_set_value_cansleep(ctx->pdata.gpio_reset, 1);
 	usleep_range(10000, 11000);
 
 	DRM_DEV_DEBUG_DRIVER(dev, "power on !\n");
@@ -1280,9 +1280,9 @@ static void anx7625_power_standby(struct anx7625_data *ctx)
 		return;
 	}
 
-	gpiod_set_value(ctx->pdata.gpio_reset, 0);
+	gpiod_set_value_cansleep(ctx->pdata.gpio_reset, 0);
 	usleep_range(1000, 1100);
-	gpiod_set_value(ctx->pdata.gpio_p_on, 0);
+	gpiod_set_value_cansleep(ctx->pdata.gpio_p_on, 0);
 	usleep_range(1000, 1100);
 
 	ret = regulator_bulk_disable(ARRAY_SIZE(ctx->pdata.supplies),