mtd: rawnand: marvell: don't set the NAND frequency select

marvell_nfc_setup_interface() uses the frequency retrieved from the
clock associated with the nand interface to determine the timings that
will be used. By changing the NAND frequency select without reflecting
this in the clock configuration this means that the timings calculated
don't correctly meet the requirements of the NAND chip. This hasn't been
an issue up to now because of a different bug that was stopping the
timings being updated after they were initially set.

Fixes: b252514 ("mtd: rawnand: marvell: Stop implementing ->select_chip()")
Signed-off-by: Chris Packham <chris.packham@alliedtelesis.co.nz>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Link: https://lore.kernel.org/linux-mtd/20230525003154.2303012-2-chris.packham@alliedtelesis.co.nz

Author: cpackham-atlnz

drivers/mtd/nand/raw/marvell_nand.c

@@ -2900,10 +2900,6 @@ static int marvell_nfc_init(struct marvell_nfc *nfc)
 		regmap_update_bits(sysctrl_base, GENCONF_CLK_GATING_CTRL,
 				   GENCONF_CLK_GATING_CTRL_ND_GATE,
 				   GENCONF_CLK_GATING_CTRL_ND_GATE);
-
-		regmap_update_bits(sysctrl_base, GENCONF_ND_CLK_CTRL,
-				   GENCONF_ND_CLK_CTRL_EN,
-				   GENCONF_ND_CLK_CTRL_EN);
 	}
 
 	/* Configure the DMA if appropriate */